From 9d6a61250468a1fdc1619a2879500641b1d11e93 Mon Sep 17 00:00:00 2001 From: Jon Sands Date: Tue, 24 Jul 2018 01:20:50 -0400 Subject: [PATCH] clear up reflash info (jtag) --- documentation/jtag.md | 4 ++-- 1 file changed, 2 insertions(+), 2 deletions(-) diff --git a/documentation/jtag.md b/documentation/jtag.md index 98d3f8a..25e57ed 100644 --- a/documentation/jtag.md +++ b/documentation/jtag.md @@ -88,10 +88,10 @@ When that finishes, connect a serial console cable to the LB6M switch (while it reset run ``` The switch should boot normally and you should see it's usual boot text in your serial console. ->If you don't see any text in your serial window and the switch seems like it's still bricked, halt it again from the JTAG window by running `reset halt` and follow the above erasing and flashing steps again as you must have skipped something. +>If you don't see any text in your serial window and the switch seems like it's still bricked, Unplug the switch power, then plug it back in, then follow the above erasing and flashing steps again as you must have skipped something. Once you have confirmed it has booted succesfully - unplug/power off the switch - do not run it for very long with the top off - once the ASIC is initialized it gets VERY hot without any airflow being forced over it. ->This is not an issue when initially booting the switch with JTAG, as the CPU is halted before it has a chance to bring the ASIC online. it is only once the switch boots succesfully in which it will begin heating. +>This is not an issue when initially booting the switch with JTAG, as the CPU is halted before it has a chance to bring the ASIC online. It is only once the switch boots successfully in which it will begin heating. Unplug the switch power first! When the switch is off and powered down, then unplug the power cable from the BDI2000, then disconnect it from the JTAG header, and you are done. **PLEASE SEND ME THE badboot.bin FILE FROM YOUR TFTP SERVER!** This will allow me to see exactly what got corrupted on your switch.